Asus H87M-PLUS - Manual (Page 68)

3-16 Chapter 3: BIOS setup
Chapter 3
CPU Internal Power Fault Control
Thermal Feedback [Auto]
Allows your system to take precautionary actions to be taken by the
CPU when the thermal conditions of the external regulator exceeds the
threshold. Configuration options: [Auto] [Disabled] [Enabled]
CPU Integrated VR Fault Management [Auto]
Disable this item to prevent tripping the Fully Integrated Voltage Regulator
when doing over-voltage. We recommend you to disable this item when
overclocking. Configuration options: [Auto] [Disabled] [Enabled]
CPU Internal Power Configuration
CPU Integrated VR Efficiency Management [Auto]
Allows you to improve power saving when the processor is in low power
state. Disable to make the Fully Integrated Voltage Regulator work in high
performance at all times. Configuration options: [Auto] [High Performance]
[Balanced]
Power Decay Mode [Auto]
Allows your system to improve the power saving mode on the Fully
Integrated Voltage Regulator as the processor goes into low current state.
Configuration options: [Auto] [Disabled] [Enabled]
Idle Power-in Response [Auto]
Allows you to set the slew rate for the Fully Integrated Voltage Regulator
as it enters manual override mode. Configuration options: [Auto] [Regular]
[Fast]
Idle Power-out Response [Auto]
Allows you to set the slew rate for the Fully Integrated Voltage Regulator as
it exits manual override mode. Configuration options: [Auto] [Regular] [Fast]
Power Current Slope [Auto]
Allows you to set the gradient of the high-speed active phase current
balance during load transients to eliminate current imbalance that can
result from a load current oscillating near the switching frequency.
Configuration options: [Auto] [LEVEL -4] - [LEVEL 4]
Power Current Offset [Auto]
Allows you to increase or decrease the output current sensed by the CPU.
It finds the balance between optimal regulating while staying below the
current threshold. Configuration options: [Auto] [100%] [87.5%] [75.0%]
[62.5%] [50.0%] [37.5%] [25.0%] [12.5%] [0%] [-12.5%] [-25.0%] [-37.5%]
[-50.0%] [-62.5%] [-75.0%] [-87.5%] [-100%]
Power Fast Ramp Response [Auto]
Allows you to increase to enhance the response of the voltage regulator
during the load transient. Configuration options: [Auto] [0.00] - [1.50]
CPU Internal Power Saving Control
Power Saving Level 1 Threshold [Auto]
Lower value provides sufficient overclocking tolerance to enlarge the
overclocking potential. Higher value provides better power-saving condition.
Use <+> and <-> key to adjust the value. The values range from 0A to 80A
at 1Amp increment.