Asus ESC1000 Personal SuperComputer - Manual (Page 114)

5-8 Chapter 5: RAID configuration
5.3 Marvell ® SAS RAID configurations
The Marvell ® SAS controller allows you to configure RAID 0 and 1 set on the SAS
hard disk drives.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set.
To do this:
1. Install two internal SAS hard disk drives to the SAS connectors labeled
SAS1/2.
2. Boot up your computer, and press during POST to enter the BIOS
setup.
3. In the Advanced menu, go to Onboard Devices Configuration, and enable
both Marvell SAS and SAS Boot ROM.
4. Press to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
Onboard Devices Configuration
High Definition Audio [Enabled]
Front Panel Type [HD Audio]
Marvell Storage Controller [Legacy Mode]
Marvell Storage Boot ROM [Disabled]
Marvell SAS [Enabled]
SAS Boot ROM [Enabled]
Realtek LAN1 [Enabled]
Realtek LAN2 [Enabled]
LAN Boot ROM [Disabled]
Onboard 1394 Controller [Enabled]
BIOS SETUP UTILITY
Advanced
Options
Enabled
Disabled