Asus P5Q-E/WiFi-AP User Manual

Page 159

ASUS P5Q-E

4-49

Using Drive Xpert funcition in BIOS setup environment

You may use Drive Xpert function in BIOS setup environment. Enter BIOS setup

by presssing DEL key after powering on. Go to Advanced menu, select Onboard

Device Configuration, then press .

Select Screen

Select Item

+- Change Option

F1 General Help

F10 Save and Exit

ESC Exit

Onboard Device Configuration

High Definition Audio

[Enabled]

Front Panel Type

[HD Audio]

Marvell IDE

[Enabled]

PCIE IDE Boot ROM

[Enabled]

Marvell LAN1

[Enabled]

LAN Boot ROM

[Disabled]

Marvell LAN2

[Enabled]

LAN Boot ROM

[Disabled]

Agere Firewire 1394

[Enabled]

Drive Xpert Mode Update [Mode change]

Update to Super Speed [Press Enter]

Update to EZ Backup

[Press Enter]

Update to Normal Mode [Press Enter]

Serial Port1 Address

[3F8/IRQ4]

Enable or Disable

High Definition Audio

Controller

BIOS SETUP UTILITY

Advanced

Drive Xpert Mode Update [Current setting]

Set this item to [Mode change] to show further settings of the Drive Xpert

Mode change] to show further settings of the Drive Xpert

] to show further settings of the Drive Xpert

function. Configuration options: [Current setting] [Mode change]

Update To Super Speed [Press Enter]

This item appears only when the Drive Xpert Mode Update item is set to [Mode

change] and allows you to use Super Speed function. Plug two identical SATA hard

drives in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on

SATA_E2 (white, port 1) connectors on

the motherboard and press the key.

and press the key.

Update To EZ Backup [Press Enter]

This item appears only when the

when the Drive Xpert Mode Update item is set to [Mode

change] and allows you to use

and allows you to use

allows you to use EZ Backup function. Plug two identical SATA hard

. Plug two identical SATA hard

drives in the SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on

SATA_E1 (orange, port 0) and SATA_E2 (white, port 1) connectors on

connectors on

the motherboard and press the key.

and press the key.

Make necessary backup before using the Drive Xpert function:
• All original data of the hard drive connected to the SATA_E2 (white, port 1)

connector on the motherboard will be erased for EZ Backup setup

• All original data of the two hard drives will be erased for Super Speed

setup.

Update To Normal Mode [Press Enter]

This item appears only when the

when the Drive Xpert Mode Update item is set to [Mode

change] and allows you to use the SATA_E1 (orange, port 0) and SATA_E2 (white,

and allows you to use the SATA_E1 (orange, port 0) and SATA_E2 (white,

the SATA_E1 (orange, port 0) and SATA_E2 (white,

port 1) connectors as normal SATA connectors.

as normal SATA connectors.

This manual is related to the following products:

P5Q-E