Asus Blitz Extreme - Manual (Page 49)

ASUS Blitz Extreme 2-23
2.6 Jumper
1. Clear RTC RAM (CLRTC_SW)
This jumper allows you to enable the clr CMOS switch. You can clear the CMOS
memory of date, time, and system setup parameters by erasing the CMOS RTC
RAM data. The clr CMOS switch on the back I/O helps you easily to clear the
system setup information such as system passwords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Press down the clr CMOS switch.
3. Plug the power cord and turn ON the computer.
4. Hold down the key during the boot process and enter BIOS setup to
re-enter data.
Removing the cap will cause system boot failure!
• The clr CMOS switch will not function if the jumper cap on CLRTC_SW is
moved to the Disable position, but the shutdwon function in S0 mode (DOS
mode) still works.
• Make sure to re-enter your previous BIOS settings after you clear the
CMOS.
• You do not need to clear the RTC when the system hangs due to CPU
overclocking. With the C.P.R. (CPU Parameter Recall) feature, shut down
and reboot the system so the BIOS can automatically reset CPU parameter
settings to default values. If the system hangs due to overclocking of
memory timing or chipset voltage and the power button fails to function,
pressing down the clr CMOS switch will shut down the system and clear
CMOS simultaneously.
System power state G3* S5*
S0
(DOS mode)
S0
(OS mode)
S1 S3 S4
Clearing CMOS **
*G3: Power off without +5VSB power (AC power loss); S5: Power off with +5VSB power
** The system shuts down immediately.
clr CMOS switch behavior