Canon PowerShot S30 - Manual (Page 32)

30 Basic Functions
Switching the LCD Monitor Display Mode
The LCD monitor can be used to confirm an image during shooting, to replay
recorded images or to adjust menu settings. Pressing the
button switches
the LCD monitor display mode.
2 Shooting Mode
• Pressing the button cycles the LCD monitor to the next mode each time
the button is pressed.
On (No Information)
➝ On (Information View) ➝ Off
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
• The on/off setting of the LCD monitor display mode is memorized when the
camera is turned off. When the camera is turned on again it assumes the last
mode. However, when the LCD monitor is turned on and the “Change the Battery
Pack” message appears, the LCD monitor may not automatically turn on the next
time the camera is started.
• Changing the shooting mode will cause the LCD monitor to display relevant
information for about six seconds when it is turned on regardless of whether the
information view mode is on or off.
• Setting the mode dial to , or turns on the LCD monitor regardless of
whether it is set to on or off.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
• The camera shake warning icon will appear at the center of the LCD monitor in
low light conditions while the camera is preparing to shoot. When this icon
appears, use the flash or fix the camera to a tripod to shoot.
2 Replaying Mode
• The LCD monitor turns on when you turn on the camera in Replaying mode
(p. 27).
• Pressing the button cycles the information view mode each time the
button is pressed.
Single Replay: Simple Display
➞ Detailed Display ➞ No Display
Index Replay: Simple Display No Display