Installation (cont.) – OSRAM DUO User Manual
Page 3
Page 3 of 4
ON
OFF
1 2
3 4
220 - 240 V~ 50/60 Hz
L
N
PE
F1
6A/10A
L
N
PE
N
L
B
0V
DUO
P
Q
220 - 240 V~ 50/60 Hz
L
N
PE
F1
6A/10A
F1
6A/10A
L
N
PE
0V
B
N
L
B
0V
DUO
N
L
B
0V
DUO
P
P
Q
U
T
R
S
S
F
Installation (cont.)
O
N
Connection diagram
Alternative 1:
One sensor switches a load area by means of light and/or
motion detection.
P Switch contact
Q Load (ECG, lamps, etc.)
Alternative 2:
One sensor switches a load area by means of light and/or moti-
on detection. A maximum of 5 additional sensors exclusively for
motion detection are used to expand the detection area.
Precondition: DIP switches (F) 1 and 2 are set to OFF in the
slaves.
R To additional sensors (a total of 6 sensors switched in
parallel!).
S Motion signal
T Sensor in slave mode (motion detection only)
U Sensor in master mode
Limiting the motion detection area
The supplied lens cover can be used to limit the detection area
and to adjust it to local conditions.
Attaching the sensor to the ceiling
Determine a suitable installation location (see „Selecting the
installation location“).
Screw the lower section of the housing onto the ceiling.
Note: Follow step 5 to correctly align the unit.
Connect the sensor; see „Connection diagram“.
Attach the upper section of the housing to the lower section.
Make sure that the light sensor is facing the room.
Attaching the sensor to the fluorescent
lamps
Precondition: T5 or T8 lamps with a min. grid of 60 mm.
Determine a suitable installation location (see „Selecting the
installation location“).
Insert the lamp clip into the lower section of the sensor
housing
Attach the sensor to the lamp end with the lamp clip to avoid
weighing down the lamp excessively. Minimum distance to
the lampholder due to heat development of the coils: 8 cm.
If necessary, adjust the sensor installation depth to the depth
of the grid luminaire by sliding the lamp clip in or out.
N With lamp clip for 26 mm fluorescent lamp
O With lamp clip for 16 mm fluorescent lamp
Pull the upper section of the housing off of the attached
lower section.
Connect the sensor; see „Connection diagram“.
Reattach the upper section of the housing to the lower
section.