Billet Specialties Premium Tru Trac Serpentine System - Big Block Ford User Manual

Page 9

www.billetspecialties.com

Figure 3b: Install Water Pump

Apply anti-seize to the five 5/16-18 x 1-1/2” ARP 12pt. cap
screws and RTV Sealer to the two 5/16-18 x 3-1/2” ARP
12pt. cap screws. Also install a 5/16” stainless steel washer
to each screw at this time.

(A) Install first 5/16-18 x 1-1/2” ARP cap screw and washer

at the top center of the water pump and finger tighten.

(B) Thread the next 5/16-18 x 1-1/2” ARP 12pt. cap screw and washer into the next
exposed hole to the right. (C) Followed by installing one 5/16-18 x 3-1/2” ARP 12 pt. cap
screw and washer through the next exposed hole (far right driver side).

(D,E,F) Next, install three 5/16-18 x 1-1/2” ARP 12pt. cap screws with washers into the next 3
exposed holes on the bottom of the water pump.

(G) Finish water pump installation by threading final 5/16-18 x 3-1/2” ARP 12 pt. cap screw
with washer into last exposed hole on water pump passenger side.

Tighten all installed hardware on timing cover bottom and water pump evenly and slowly
in a cross pattern. Also tighten spacer nuts firmly at this time.

(A)

(B)

(C)

(D)

(E)

(F)

(G)

Use RTV Silicone on this bolt