Billet Specialties Premium Tru Trac Serpentine System - Big Block Ford - Manual (Page 13)

www.billetspecialties.com
Figure 8: Install The Alternator
Apply anti seize to one 10mm-1.5 x 100mm ARP 12pt cap screw and one 8mm-1.25 x 25mm
12pt. cap screw.
(A) Place the alternator between the timing cover and bridge bracket with the wide mount
boss at the bottom and align with bridge bracket. Thread the 10mm-1.5 x 100mm ARP 12pt.
cap screw through the bridge bracket, alternator, 1-5/16” spacer and into the timing cover,
finger tighten.
(B) Align top alternator ear with bridge bracket and thread remaining 8mm-1.25 x 25mm
ARP 12pt. cap screw through bridge bracket and into alternator.
The alternator mounting boss may vary in width due to the polishing process. 10mm shim
washers are provided to shim the alternator if needed at the bottom.
Tighten all bridge bracket fasteners, compressor shoulder
bolt and tensioner bolt behind timing cover firmly at this time.
13
(A)
(B)