Billet Specialties Premium Tru Trac Serpentine System - Big Block Ford - Manual (Page 18)

www.billetspecialties.com
Figure 13: Install A/C Compressor Manifold
Important!
• Only remove sealed cap on compressor if you plan on charging you’re A/C system.
Immediately, leaving the compressor open to outside air can introduce moisture into
the system causing the cooling system not to operate properly.
• Never connect the compressor clutch wire and run the compressor unless the system is
completely charged. Serious damage may occur to the compressor.
(A) Attach the compressor manifold by removing the protective cover and plac-
ing the manifold onto the compressor.
(B) Apply anti-seize to the two M8-1.25 x 25mm socket head cap screws and
thread through manifold into the compressor and tighten firmly.
Compressor Oil
• Although the compressor is supplied with oil, the level may not be correct for the entire
system. Consult the instruction manual of the air conditioning unit for proper levels and
system charging procedures.
• Billet Specialties recommends having your air conditioning charged and serviced by an
automotive air conditioning service center with the proper equipment to ensure many
years of trouble free service.
(A)
(B)