Billet Specialties Premium Tru Trac Serpentine System - Big Block Ford - Manual (Page 19)

www.billetspecialties.com
Figure 14: Install Belt & Tensioner Pulley
(A) Install and route belt as shown in the diagram below allowing belt to rest on pulley boss.
(B) Place a 5/8” box end wrench on tensioner nut.
(C) Align belt onto pulley groove above tensioner boss.
(D) Pull up on wrench until tensioner pulley is able to slip onto tensioner boss.
(E) Thread 3/8-16 x 3/4” ARP 12pt. bolt and thrust washer onto tensioner pulley and tighten
firmly. (46 ft/lb)
Connect electrical and fluid lines, test run motor. Inspect fittings and hardware, tighten
if necessary.
19
With Power Steering Without Power Steering
(A)
(E) (C,D)
(B)