SENA Promi-MSP User Guide - Manual (Page 48)

48
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
Ex.: DELSERV Promi-SD
+OK
REPT
: When connection to Host is failed, users may configure Retrial period of
connection. Unit: millisecond, Default value: 5000 ms
If the value is ‘0’, Promi-MSP will try to recover connection only once.
Ex.:
REPT 3000
+OK REPEAT every 3000 ms
PSIST
: In Client mode, in the event of TCP disconnection, Promi-MSP ™
automatically attempts to recover TCP connection when PSIST is set to
ON, in the period of pre-defined ms by REPT command.
Ex.: PSIST ON
+OK PERSIST on
5.4 Commands for Vertex Mode
VERTEX [number of clients]
: To assign port number where Promi-MSP waits for connection in Vertex
mode.
Promi-MSP ™ Vertex Mode avails Wireless RS485 multi-drop service
when assigned at this site.
Ex.: VERTEX 4000 1
+OK PORT 4000 MAX 1
5.5 Commands for Serial Hub Mode
ROUTE