1 network settings – SENA Promi-MSP User Guide User Manual

Page 11

2.1 Network Settings

(1) Promi-MSP

™ power-up; ‘POWER’and ‘STATUS’LEDs display green

(2) Promi-MSP

™ network configuration: connect Promi-MSP™ to PC via RS232 cable

(3) Open HyperTerminal

(4) Set PC COM port;

Baud rate 115200 / 8 Data bit / non-parity / 1 stop bit / no hardware flow control

(5) Press Enter key; the following information is displayed on HyperTerminal

screen; If Promi-MSP

™ prompts Login ID/password, default values are:

Login: admin

Password: 11111

(6)

Default Promi-MSP

™ IP address factory setting is 192.168.1.10

Revise to

user appropriate networking environment IP address

(7) To revise Network Settings, click main menu Number. Enter “1”

as displayed below.

(8)

Network Settings sub menu is displayed.

Description:

1. Static IP: For Assigning Promi-MSP

™ a static IP

2. DHCP: For Assigning Promi-MSP

™ IP using DHCP

3. PPPoE: For assigning Promi-MSP

™ IP using PPPoE

4. DHCP server: For instant network setting. Promi-MSP assigns temporary IP to

PC.

(9)

If No. 1, Static IP, is selected, the following is displayed on screen: