Configuration, 1 configuration via promi-msp software, 1 when promi-msp is connected to pc directly – SENA Promi-MSP User Guide User Manual

Page 21: 2 log in promi-msp software

3. Configuration

If users finished configuring network settings using serial console, now users need to select the

operation mode of Promi-MSP. Following three (3) ways can be used for selection of operation

mode:

1. Via Promi-MSP configuration software

2. Via Telnet (Control port)

3. Via Web browser (Internet Explorer, etc.)

In this chapter, guide to use Promi-MSP configuration software will be introduced.

How to configure via Telnet or Web browser will be introduced in Appendix.

3.1 Configuration via Promi-MSP software

3.1.1 When Promi-MSP is connected to PC directly

If users are going to connect Host PC and Promi-MSP directly using a crossed

cable, network settings as in the chapter 2.1 will not be required.

Promi-MSP has factory settings: Static IP 192.168.1.10/24 with DHCP server

For communication with Promi-MSP, just connect Promi-MSP and Host PC with a

crossed cable as below. Make sure Host PC to be configured using DHCP.

3.1.2 Log in Promi-MSP software

For easier configuration and monitoring on a specific Promi-MSP, which has been