SENA Promi-MSP User Guide - Manual (Page 16)

16
Copyright © 2006 Sena Technologies, Inc. All rights reserved.
 Then you will get following screen:
 Place the MSP upgrade ROM file which is downloaded from SENA web site to
C:\ folder on your PC and run tftp command on [Start] →[Run] as below.
 Users need to make sure that the upgrade ROM file is in the same location or users
need to specify the exact location to send the ROM file to the connected Promi-MSP
via crossed ethernet cable.
 Below window is showing the procedure of sending ROM file named
“msp2_040906.rom” to the connected Promi-MSP via TFTP.
 Users will be able to check the status of firmware upgrade in Serial console.
 During upgrade, LEDs will flash and users SHOULD NOT turn off Promi-MSP this time.
If user cannot send the ROM file, please check the network connection status.