2 display log data, 3 automatic log delivery by email – SENA PS400 User Manual
Page 55

55
F/W REV.
: V1.00
MAC Address
: 00-01-95-04-04-33
Cur Status : Running
Current time : 2038/05/10 04:34:10
---------------------------------------------------------------------------
IP information
---------------------------------------------------------------------------
IP Mode : Static
IP Expiration : N/A
IP Address : 192.168.2.100
Subnetmask : 255.255.0.0
Gateway : 192.168.1.1
Receive/Transmit errors : N/A
Primary DNS : 211.172.129.198
Secondary DNS : 211.172.129.199
------------- --------------------------------------------------------------
Port #0 information
---------------------------------------------------------------------------
Connection Mode : Modem Emul
Local port : 6000
Destination : 192.168.1.120:6010
Host allowed : 0.0.0.0/0.0.0.0
Incoming bytes : 268492
Outgoing bytes : 285121
UART : 9600-N-8-1-Hardware
Encryption : 3DES
Inactivity timeout : 300 sec
Inter-character timeout : 100 ms
...
---------------------------------------------------------------------------
Port #3 information
---------------------------------------------------------------------------
Connection Mode : TCP Server
Local port : 6003
Destination : 192.168.1.120:6013
Host allowed : 0.0.0.0/0.0.0.0
Incoming bytes : 0
Outgoing bytes : 0
UART : 9600-N-8-1-Hardware
Encryption : None
Inactivity timeout : 100 sec
Inter-character timeout : 1 ms
End of Status
Press Enter
Figure 6-2. System status display (PS400)
6.2 Display log data
Users can see the system log by selecting submenu 2.Display log. Users can also clear current
log data by selecting submenu 4.Clear log.
2002-02-10 04:41:32 > ### No valid log table. Initialize logs ###
2002-02-10 04:41:44 > ### Boot up System Start ###
2002-02-10 04:41:44 > ### Start with Static IP by 192.168.2.100 ###
End of Log
Press Enter
Figure 6-3. System log display
6.3 Automatic log delivery by email
The HelloDevice Pro Series can be configured to send log data automatically if the number of log
messages unsent reaches the pre-defined number. Users can enable this feature by selecting
submenu 5.Send log by email. If this feature is enabled, you have to configure email related