SENA LS100W - Manual (Page 40)

40
5.3.2 TCP Server/Client Mode Configuration
To configure the LS100W to work as a TCP server/client mode, use ‘set’command as follows:
set host tcpsc listening_port dest_ip dest_port cyclic_connection_interval inactivity_timeout
where,
listening_port = listening TCP port
dest_ip = destination IP address
dest_port = destination TCP port
cyclic_connection_interval = cyclic connection interval in minutes
inactivity_timeout = inactivity timeout in seconds.
Parameter definitions for TCP server and client mode configuration are the same with TCP server
mode and TCP client mode parameters.
Figure 5-6 shows TCP server/client mode setting example:
> set host tcpsc 6001 192.168.1.100 7001 10 300
OK
>
Figure 5-6 TCP server/client mode setting