SENA LS100W - Manual (Page 12)

12
Figure 2-2. Connecting the Power to the LS100W
2.2.2 Connecting to the Wireless LAN
An 802.11b Wireless LAN card is embedded in the LS100W. When power is connected correctly, the card will
automatically search for the Wireless LAN access point and attempt to connect to the Wireless LAN
access point (AP). If the Wireless LAN cable is properly connected to the Wireless LAN access point,
the LS100W will have a valid connection to the Wireless LAN network. A proper connection will be
indicated as follows:
- The [Link] LED lamp on the LS100W front panel will remain solid orange.
- The [Act] LED lamp on the LS100W front panel will blink continuously to indicate that incoming and
outgoing Wireless LAN packets are being transferred
To connect the LS100W to a Wireless LAN access point, users must first set the corresponding
information on the LS100W, such as the SSID of the Wireless LAN access point.
Please refer to the Wireless LAN Settings section in Chapter 3 to set the appropriate parameters for a
Wireless LAN connection.
2.2.3 Connecting to the Device
Connect the serial data cable to the LS100W and the serial device as shown below. Ensure that power
has been correctly supplied to both the serial device and the LS100W.