Littelfuse C6200 Flexgen Series - Manual

Generator Control
© 2013 Littelfuse Protection Relays & Controls
G
LOAD
G G G
C6200
(Generator Control)
C6200
(Generator Control)
C6200
(Generator Control)
C6200
(Generator Control)
G G G
LOAD LOAD
BASIC
COMPACT
ADVANCED
BASIC
G G G G
C6200
C6200 C6200 C6200
C6200
C6200 C6200 C6200
G
LOAD
G G G
C6200
(Generator Control)
C6200
(Generator Control)
C6200
(Generator Control)
C6200
(Generator Control)
G G G
LOAD LOAD
BASIC
COMPACT
ADVANCED
BASIC
G G G G
C6200
C6200 C6200 C6200
C6200
C6200 C6200 C6200
G
LOAD
G G G
C6200
(Generator Control)
C6200
(Generator Control)
C6200
(Generator Control)
C6200
(Generator Control)
G G G
LOAD LOAD
BASIC
COMPACT
ADVANCED
BASIC
G G G G
C6200
C6200 C6200 C6200
C6200
C6200 C6200 C6200
Grid Parallel Island Mode Grid Parallel with Local Bus
www.littelfuse.com/c6200
Basic and Advanced
C6200 Flexgen SerieS
Generator Control
Description
FlexGen controllers are intended for paralleling of generators
with each other or with the grid. One FlexGen controller is
installed for each generator in the installation and handles all
electrical control.
There are two versions available, Basic and Advanced.
Both versions include basic functions such as autosynchronizing,
frequency control, active load sharing, dead bus monitoring and
reverse power protection. In addition the FlexGen Advanced
contains reactive load sharing, voltage matching, power factor
control, grid-parallel operation control, and protection against
excitation loss, RoCoF (df/dt), and vector shift. FlexGen Advanced
also contains over-current and short-circuit protection and power
management features like preferential load trip, load depending
start/stop and large consumer control.
Both models include MODBUS RTU interface enabling integration
with equipment from other manufacturers, for example, control
and monitoring from PC with a graphic SCADA interface. FlexGen
is type-approved by major marine classification societies and can
be used for marine power management systems.
C6500 FlexGen UI User Interface Module
Provides indication of measurements, alarms,
alarm log and configuration of the generator
module.
The user interface is designed for mounting
in the switch panel door. It furnishes a large
back-lit display showing all electrical measurements and
control parameters.
g
User interface unit for any FlexGen controller
g
Separate LEDs provide clear indication
g
Valuable alarm log
g
Onsite configuration capability
g
Connects through the RS232 serial link
Accessories
ACCeSSorieS requirement
C6500 Recommended
ordering numBer model nAme
C6200.0060 FlexGen Basic
C6200.0100 FlexGen Advanced
Ordering Information
Simplified Circuit Diagram
Rev: 4-A-050313