beautypg.com

En g li sh – Factory Direct Hardware Pfister 001-9120 01 Series User Manual

Page 4

background image

EN

G

LI

SH

ENGLISH

10

11

9

11 HANDLE INSTALLATION OR REMOVAL

These instructions cover two different types of handle installations Windsor™ (11A)

and Verve™ (11B).

Before proceeding, close all Valves. Attach Handles (11A or 11B) onto Stems (11C)

and secure with Screws (11D). Attach Buttons (11E) “H” on Left, (11F) “C” on Right,

and (11G), “Arrow in center..

Reverse procedures to remove.

9 SHOWER ARM & SPOUT INSTALLATION

Apply PTFE plumber’s tape to both ends of Shower Arm (9A) according to manufacturer’s

instructions. Insert the end of Shower Arm (9A) through the Shower Flange (9B).

Screw the end of Shower Arm (9A) into the pipe elbow inside the wall. Slide Shower

Flange (9B) tight to the wall.

Apply PTFE plumbers tape on both ends of Pipe Nipple (9C) according to manufacturer’s

instructions. Screw Pipe Nipple (9C) onto the elbow inside the wall and tighten with

pipe wrench. The Pipe Nipple (9C) is to project 3

” to 4” from the finished wall. Insert

Protective Washer (9D) onto Pipe Nipple (9C). Screw Tub Spout (9E) onto Pipe Nipple

(9C) and tighten until Spout is properly positioned and flush to the finished wall.

10 FLANGE INSTALLATION

Remove stem protectors (10A) from Valves (10B). Screw Threaded Nipples (10C) into

Valves (10B). Place Protective Washers (10D) onto Valves (10B). Screw Flanges (10E)

onto Threaded Nipples (10C) and hand tighten Flanges (10E) until snug against wall.

Reverse procedures to remove.

4

9A

9C

9D

9E

9B

10A

10D

10E

10C

10B

11A

11B

11C

11C

11F

11D

11D

11F

11G

11E

3

7

/

8

” to 4”

(98 to 102 mm)

This manual is related to the following products: