Swanstone MF-1W - Installation - Manual (Page 8)

Q Quuiicckk R Reeffeerreennccee A Asssseem mbbllyy
1. Prior to installation of the laundry tub, first attach the
legs to floor mount models (Step 1a) or attach the
filler brackets to the wall mount models (Step 1b).
Refer to the specific section in this manual for
detailed instructions.
2. Attach the wall mounting plate to the wall. (Step 2a,
2b, or 2c).
3. Finally, install faucet and P-trap onto the laundry tub.
4. Install laundry tub.
5. Anchor floor mount units to the floor (optional).
6. Install splash guard (optional).
1. Attach Legs / Filler Brackets
11aa.. A Attttaacchh M Meettaall LLeeggss — — M MFF-11FF aanndd
M MFF-22FF ((S Siinnggllee aanndd D Doouubbllee B Boow wll
M Mooddeellss))
1. Place the laundry tub upside down on a flat surface.
Protect the top edges of the laundry tub from
scratches or other damage by placing cardboard or
other scratch resistant material on the floor.
2. Slide the metal leg into one of the plastic corner
retaining sockets in the bottom of the laundry tub.
All four legs are identical and can be installed in any
one of the four corners.
3. Place a block of scrap wood over the end of the leg
and drive the leg down into the socket with a
hammer.
4. Install the other three legs in the same manner.
LT-003
LT-002
LT-001
The Swan Corporation – Swanstone 8 800-325-7008
General Information Installation Procedure