Swanstone MF-1W - Installation - Manual (Page 12)

3. Insert the plastic anchor into the hole and drive it in
until it is flush with the wall surface. For single bowl
models use at least three anchors. For double bowl
models use at least six anchors.
4. Attach the mounting plate to the wall with 1/4" x
1-1/2" long Phillips head screws (supplied with unit).
For single bowl models use at least three screws.
For double bowl models use at least six screws.
Note: Make sure the wall mounting plate is straight,
regardless of the wall contour, before completely
tightening the screws. If the wall is not flat, shim
behind the mounting plate, as needed.
22cc.. A Attttaacchhiinngg W Waallll M Moouunnttiinngg P Pllaattee ttoo
C Coonnccrreettee oorr B Blloocckk W Waallllss w wiitthh T Taappccoonn
W Waallll A Anncchhoorrss ((U Usseerr S Suupppplliieedd))
1. Locate the wall mounting plate in the same manner
as with wood construction.
Note: Trial fit the wall mounting plate to the laundry tub.
If the wall plate is too long, break off the left side
of the wall mounting plate by snapping it along
the plate’s scored ridge.
Oversized holes may make it impossible to properly hold
the Tapcon screw and will reduce the load (holding)
capacity. This reduced holding capacity can result in the
screw pulling free from the wall, resulting in possible
personal injury or even death.
2. Drill a 3/16" pilot hole into the wall using a masonry
bit and hammer drill.
Note: Always follow the mounting hardware
manufacturer’s recommendation for installation of
their mounting hardware.
WARNING
LT-024
LT-028
LT-027
The Swan Corporation – Swanstone 12 800-325-7008
Installation Procedure