Swanstone FBF-1260 - Installation - Manual

NEW
BARRIER FREE SHOWER FLOOR & RAMP
Installation Instructions
Barrier Free Shower Floor and Ramp
CROSS SECTION VIEW
MODEL SIZE
ROUGH-IN DIMENSIONS
A B C D
BF-3060 SHOWER FLOOR 30 Љ X 60Љ 60-3/8 Љ 30-3/16Љ 8 Љ 15 Љ
BF-1260 RAMP 12 Љ X 60Љ 60 Љ 12 Љ — —
Shower floor is available in either a right or left side drain.
INSTALLATION TIPS
A. Read instructions carefully and familiarize yourself with the parts.
B. Be certain the barrier free shower floor is the correct size and in good condition before beginning installation.
C. Make sure hole in sub-floor or slab is large enough to accommodate drain and will coincide with the hole in
the barrier free shower floor. Hole should be 6
Љ in diameter.
D. Make sure barrier free shower floor is level and all feet of the barrier free shower floor are making firm contact
with the sub-floor. It may be necessary to shim under the barrier free shower floor for best overall sub-floor
contact. For a more stable installation, it is suggested that the barrier free shower floor be nested in a bed or
mortar-type material (Quikrete). Improper installation will void the warranty.
E. Finished walls may be tiled-in over integral flanges of barrier free shower floor.
NOTE: If the barrier free shower floor installation calls for the barrier free shower floor ramp, it is essential that
the stainless steel clips be attached to the threshold of the barrier free shower floor prior to final fit. See the
reverse side of this sheet for the correct procedure for attaching these clips.