Swanstone MF-1W - Installation - Manual (Page 15)

3. Attach the PVC tailpiece (homeowner supplied) to
the drain pipe. Cut the tailpiece to the proper length
using a hacksaw, if necessary. Use sandpaper or a
file to remove any burrs or sharp edges.
4. Attach the flexible water supply lines to the water
shut off valves. The threaded ends of the water lines
can be wrapped with Teflon pipe tape to ensure a
tight, leak-proof seal. Tighten the fitting with a
wrench but do not over-tighten.
5. The water lines and waste pipes should now be
completely installed.
6. Slowly turn ON the hot and cold water shut off
valves. Turn the faucets ON and flush the water
lines to remove any debris that may be in the water
line or the drain pipe.
LT-013
LT-012
LT-011
LT-010
800-325-7008 15 The Swan Corporation – Swanstone
Installation Procedure