Swanstone MF-1W - Installation - Manual (Page 13)

3. Attach the mounting plate to the wall with 1/4" x
1-1/2" long Tapcon Hex Head Masonry Screws. Do
not overtighten the screws. For single bowl models
use at least three screws. For double bowl models
use at least six screws.
Note: Make sure the wall mounting plate is straight,
regardless of the wall contour, before completely
tightening the screws. If wall is not flat, shim
behind the mounting plate, as needed.
33.. IInnssttaalllliinngg tthhee FFaauucceett aanndd D Drraaiinn
1. Shut off the water supply to the entire house or at
the location of the old sink.
2. Release the pressure and drain the water lines by
turning on a faucet in the lowest part of the house.
Turn on both the hot and cold water faucets.
3. If replacing an existing laundry tub, loosen and
remove the hot and cold water lines and waste pipe
connections. Use a container to catch any water
remaining in the P-trap.
Note: If the P-trap and water lines are in poor condition,
replace them with new parts. Also replace any
rusted or corroded fittings with new parts. The
faucet can be reused and reinstalled.
4. Install the faucet assembly according to the
manufacturer’s instructions (homeowner supplied).
Note: Preinstallation of the faucet, supply lines, and
P-trap are easier when the laundry tub is not
against and/or attached to the wall.
5. Attach the two flexible water lines onto the faucet
(homeowner supplied). Do not over-tighten the
connections.
LT-007
LT-006
LT-029
800-325-7008 13 The Swan Corporation – Swanstone
Installation Procedure