Swanstone RM-58 - Installation - Manual (Page 4)

IMPORTANT NOTICE: Indicates that equipment or
property damage can result if instructions are not
followed.
Read and Understand the Manual
It is the responsibility of any individual who
installs or maintains this product to fully
understand and follow proper installation and
maintenance procedures. Be aware of the inherent
dangers in the use of power tools when installing this
product. Read and understand all Warnings, Cautions,
and Important Notices in this manual.
Work Safely
DO NOT proceed if any doubt arises about the
correct or safe method of performing anything
found in this or other Swan Corporation
manuals. The installation of this product can require
using power tools. Do not use power tools without
adequate training. If necessary, hire or consult a trained
professional for expert assistance before continuing.
Use Proper Tools
Always use proper tools which are in good,
working condition during the installation of the
Swan Corporation products. Using tools other
than those listed could adversely affect the integrity of
floors, pipes, walls, or this product and could result in
water damage or other damage to floors, pipes, walls, or
other portions of your building or home.
Do Not Use Nails
The panels mount to walls with clear silicone
only. Only use the supplied or recommended
clear silicone to mount this product. Never
use hammers, nails, or screws. Hammers, nails, and
screws could adversely affect the integrity of this
product. Nails and screws could puncture the Swan
Corporation Wall Systems and Panels, resulting in water
or other damage to floors, pipes, walls, or other portions
of your building or home.
Inspect Before Cutting
Make sure no electrical wiring or plumbing is
present before cutting into a wall to install any
accessories.
Wall Conditions
Inspect the walls before installing the Swan
Corporation panels. Never install panels over
damp walls or an existing mold condition.
CAUTION: Indicates a potentially hazardous
situation which, if not avoided, may result in injury. It
may also be used to alert against unsafe practices.
Use Proper Installation Methods
Follow all instructions related to wall surface
preparation. Failure to follow such instructions
could cause the panels to detach from the wall
surface after installation, resulting in personal injury.
Failure to follow these instructions could result in water
damage.
Lifting Hazard
According to the National Institute for
Occupational Safety and Health, the
recommended maximum safe lifting weight is
51 pounds, with all lifting conditions perfect—minimal
forward reach, steady load close to the body, straight
back, load between knees and shoulders, and good
grips. To avoid personal injury, always use these proper
lifting techniques and use two people to move cartons
weighing more than 51 lbs. The boxes containing the
Swan Corporation kits can weigh in excess of 80
pounds. Use the appropriate lifting devices to move the
load. Always use two people when lifting heavy or bulky
cartons. DO NOT attempt to lift objects that are too
heavy.
WHEN CARRYING A HEAVY LOAD—GET HELP!
Slipping Hazard
Do not install this product in the presence of
water. Installing this product without drying all
surfaces, or in the presence of water, could
cause you to slip and fall due to wet floors or spilled
fluids. Personal injury can result from slips or falls.
Before installation, dry all surfaces, including the floor,
with a cloth or paper towel. Clean up all water or spilled
fluids immediately.
Tripping Hazard
Personal injury can result from tripping over
power cords, tools, or other items. DO NOT
leave items laying around the work area.
Personal Protection
Be sure to use all personal protective
equipment, such as sturdy work
boots, preferably with steel toes,
gloves, and hard hat, if necessary, to ensure your own
safety. To prevent possible damage to your hearing,
always wear ear protection, such as earmuffs or
earplugs, when working around power tools.
CAUTION IMPORTANT NOTICE
The Swan Corporation 4 800-325-7008
Safety Guidelines