Swanstone RM-58 - Installation - Manual (Page 14)

4. Carefully position the corner panel and firmly press
the surface of the corner panel against the walls.
Apply hand pressure up and down and side-to-side,
making sure all areas are in firm contact with the
wall. It is important to apply hand pressure to the
entire surface of the panel to bond it to the wall
surface.
5. Except for corner shower wall kits, repeat Step 1
through Step 4 to install the remaining corner panel.
Note: Make sure the top edge of both corner panels are
at the same height, measured from the top of the
bathtub or shower floor ledge.
Side Panels
Most side panels are designed to fit a certain way.
Check for identification tags on the back of panels
and/or bullnose edges, which align with the front edge of
the bathtub, shower floor, or apron strips, if installed.
1. Measure the openings for faucet(s), bathtub spout,
and/or shower head. Measure the height up from
the ledge of the bathtub or shower floor ledge.
Measure in from a straight line drawn up from the
front edge of the bathtub, shower floor, or apron strip
(trial fit apron strips when taking measurements).
2. Use the measurements to make a cardboard
template in order to check for proper fit around
plumbing outlets. Trial fit the cardboard template,
and adjust as necessary.
3. Transfer the template measurements to the side
panel to be installed over the plumbing outlets.
Dust Hazard
When cutting or drilling the Swan
Corporation product, use a dust
collection method which prevents dust
particles from going into the air. Always work in a well-
ventilated area. To keep the area well-ventilated, open
windows and use exhaust fans. Always use an OSHA
approved dust mask when cutting, drilling, or sanding
Swan Corporation products.
WARNING
The Swan Corporation 14 800-325-7008
Installation Procedure