Warning, Installation procedure – Swanstone RM-58 - Installation User Manual
Page 18

Fumes Hazard
The fumes from the silicone and
solvents used by the installer can be
harmful if used in an unventilated room.
Always work in a well-ventilated area. To keep the area
well-ventilated, open windows and use exhaust fans. If
adequate ventilation is not achievable or practical, use
respiratory protective equipment.
2.
Clean the back of the panel with denatured alcohol.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from properly adhering to the wall.
3.
Apply the silicone in 1-1/4 inch diameter dots every
8 to 10 inches over the back surface of the panel.
Follow the silicone manufacturer’s instructions and
note all ventilation and installation precautions.
4.
Install the back panel. Carefully center the
overlapping panel and press firmly to the wall. Keep
the top edge of the panels aligned when installing
adjacent panels. Use even hand pressure from top
to bottom and side-to-side to ensure solid wall
contact.
Note: Any gaps between the bottom of the panels and
the tub ledge will be filled in with caulking in a later step.
IMPORTANT NOTICE
WARNING
The Swan Corporation
18
800-325-7008
Installation Procedure