Swanstone RM-58 - Installation - Manual (Page 22)

7. Clean the back of the panel with denatured alcohol.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from properly adhering to the wall.
8. Apply the silicone in 1-1/4 inch diameter dots every
8 to 10 inches over the back surface of the panel.
Follow the silicone manufacturer’s instructions and
note all ventilation and installation precautions.
9. Carefully position the corner side panel tight against
the corner and firmly press the surface of the panel
against the walls. The corner side panel should not
extend all the way to the front edge of the bathtub.
10. Apply hand pressure up and down and side-to-side,
making sure all areas are in firm contact with the
wall. It is important to apply hand pressure to the
entire surface of the panel to bond it to the wall
surface.
11. Repeat Step 6 through Step 9 to install the
remaining corner side panel.
Note: Make sure the top edge of both the corner side
panels are at the same height, measured from the tub
ledge.
IMPORTANT NOTICE
The Swan Corporation 22 800-325-7008
Installation Procedure