Swanstone RM-58 - Installation - Manual (Page 25)

2. Measure, mark, and cut the sill panel to window sill
depth measurement (B). Trial fit the sill panel.
Sand the cut edge with medium grit sandpaper.
3. Measure, mark, and cut the left and right vertical
panels to window jam depth measurement (B). Trial
fit all three panels. If necessary, trim height (C) of
the vertical panels to line up with the top edge of the
tub or shower wall panels. Sand the cut edges with
medium grit sandpaper.
4. Apply silicone adhesive to the underside of the sill
panel, as shown. Install the sill panel, centered in
the window opening, 3/4 inches from each side wall.
Note: Press the front lip of the sill panel tightly against
the existing tub or shower wall panel.
5. Apply silicone adhesive (A) to a vertical panel as
shown. Apply a bead of color coordinated caulk (B)
to the edge that fits against the sill panel, as shown.
Install the vertical panel and press into place so the
silicone adhesive makes good contact.
A
A
B
C
C
B
B
B
800-325-7008 25 The Swan Corporation
Installation Procedure