Swanstone RM-58 - Installation - Manual (Page 27)

To prevent scratches or other damage, make sure there
are no nails or other foreign objects in the surface of the
bracing that is placed against the panel. Also, to prevent
possible damage to the walls, do not apply excessive
pressure to the braces. Do not hammer (pound) braces
in place or nail the braces together.
2. Place two braces against each left and right wall.
3. Install (wedge) horizontal braces against the left and
right wall braces.
4. Insert (wedge) blocks or cross braces between the
front to rear panel braces and the back panel
braces. These blocks or braces must apply
pressure to the back panel to hold it in place.
5. Remove the braces after 24 hours.
IMPORTANT NOTICE
800-325-7008 27 The Swan Corporation
Installation Procedure