Derale Performance 13" High Output Single RAD Puller Fan with Plastic Shroud - Manual

16926-InstructionSheet
INSTALLATION INSTRUCTIONS
HIGH OUTPUT SINGLE RAD FAN
PART # 16926
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
WIRING
TIPS
Always disconnect vehicles battery before beginning installation involving your vehicles electrical system.
All 12 Volt Positive leads require the use of the appropriate fuse load rating to avoid damage to your vehicles electrical system.
Always insist on using only high quality components (wire, connectors, and switch) for use in installation of your new Derale
Electric Fan Assembly.
MOUNTING
1. Position the electric fan against the radiator in the desired location.
2. Take the Plastic Rods provided and install through the four mounting
holes on the shroud pushing them slowly into and through the radiator
core. (See Diagram #2)
Do not use excessive force when pushing Mounting Rods
through radiator core. Excessive force could cause damage to the
radiator fins and/or core. Plastic Rods should not be inserted thru both
the radiator and the condenser cores.
3. Take the 1 x 1 Foam Pads provided and install them onto the Plastic
Rods now protruding through the radiator core. (See Diagram #2)
4. Take the Mounting Clips provided, making sure they are in the correct
direction (Derale writing out) install onto the Plastic Rods and cinch
them until the 1 x 1 Foam Pads are compressed. (See Diagram #2)
5. Cut off the excess Mounting Rods.
Caution:
Please read these instructions completely before beginning installation
Diagram #1
Engine
Puller Fan
Air Flow
Radiator
TOOLS NEEDED
Dyke Pliers
5/16” Open End Wrench
Standard Screw Driver or
5/16” Nut Driver
Drill
5/32” Drill Bit
12V Test Light
Wire Stripper
Crimping Tool
IMPORTANT
This fan assembly is designed for PULLER APPLICATIONS
ONLY Engine side of radiator.
(See Diagram #1)
KIT CONTENTS
QTY. DESCRIPTION
1 Fan Shroud Assembly
1 Relay Wire Harness
4 Mounting Rods
QTY. DESCRIPTION
4 Mounting Clips
4 1x1 Foam Pads
1 #10 Sheet Metal Screws
Diagram #2
Mounting
Clips
Mounting
Rods
Foam
Pads
Electric Fan
Assembly
RELAY WIRE HARNESS MOUNTING
1. Taking into consideration fan placement & wire routing requirements, choose
a convenient location. Avoid mounting near HOT engine components.
2. Using the relay bracket as a template, mark and drill a 5/32” hole in the
proper location.
3. Using the #10 Sheet Metal Screw
provided, install the relay/wire harness.
(See Diagram #3)
(Continues on reverse side)
RELAY
Diagram #3
Mounting
Surface