Derale Performance High Output Dual 13" Electric RAD Fan_Plastic Shroud Kit - Manual

Rev.-061611
INSTALLATION INSTRUCTIONS
HIGH OUTPUT DUAL RAD FAN ASSEMBLY
PART # 16928 & 16934
KIT CONTENTS
QTY. DESCRIPTION
1 Left Shroud Assembly
1 Right Shroud Assembly
4 Fan Shroud Assembly Screws
2 #10 Sheet Metal Screws
QTY. DESCRIPTION
8 Mounting Rods
8 Mounting Clips
8 1x1 Foam Pads
2 Relay Wire Harness
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
MOUNTING
1. Position the electric fan against the radiator in the desired
location.
2. Take the Plastic Rods provided and install through the four
mounting holes on the shroud pushing them slowly into
and through the radiator core. (See Diagram #3)
Do not use excessive force when pushing Plastic
Rods through radiator core. Excessive force could cause
damage to the radiator fins and/or core. Plastic Rods
should not be inserted thru both the radiator and the
condenser cores.
3. Take the 1 x 1 Foam pads provided and install them onto
the Plastic Rods now protruding through the radiator core.
(See Diagram #3)
4. Take the Plastic Clips provided, making sure they are in
the correct direction (Derale writing out) install onto the
Plastic Rods and cinch them until the 1 x 1 Foam Pads are
compressed. (See Diagram #3)
5. Cut off the excess Plastic Rod.
Caution:
Diagram #2
Right Shroud Assembly
Please read these instructions completely before beginning installation
PRE-INSTALLATION
1. Identify the Right and Left Shroud Assembly and
Fan Shroud Assembly Screws
2. Using a table or flat surface, lay both the Right &
Left Shroud Assemblies on the flat surface with
the fan motors both facing up.
(See Diagram #2)
3. Slide both shrouds together lining up the
mounting holes. (See Diagram #2)
4. Carefully install the 4 Fan Shroud Assembly
Screws into each of the mounting holes and
tighten.
Do not over tighten! Note:
(Continues on reverse side)
Diagram #3
Mounting
Rods
Mounting
Clips
Foam
Pads
Electric Fan
Assembly
RELAY WIRE HARNESS MOUNTING
1. Taking into consideration fan placement and wire routing requirements,
choose a convenient location. Avoid mounting near HOT engine components.
2. Using the relay bracket as a template, mark & drill a 5/32” hole in the proper location.
3. Using the #10 Sheet Metal Screws provided, install the relay/wire harness.
(See Diagram #4)
IMPORTANT
This fan assembly is designed for PULLER APPLICATIONS
ONLY Engine side of radiator.
(See Diagram #1)
Diagram #1
Engine
Puller Fan
Air Flow
Radiator
TOOLS NEEDED
Dyke Pliers
5/16” Open End Wrench
Standard Screw Driver
or 5/16” Nut Driver
Drill
5/32” Drill Bit
12V Test Light
Wire Stripper
Crimping Tool
Left Shroud Assembly
RELAY
#1
RELAY
#2
Diagram #4
Mounting
Surface
16928-16934-InstructionSheet