Derale Performance Aluminum Tornado Electric Fan Mounting Bracket Kit, Single Fan - Manual

INSTALLATION INSTRUCTIONS
UNIVERSAL FAN MOUNTING BRACKET KIT
PART # 16700
KIT CONTENTS
QTY. DESCRIPTION
2 Large Mounting Bracket
4 Small Mounting Bracket
4 M6 x 12MM Hex Bolt
8 M6 Lock Nut
QTY. DESCRIPTION
4 Star Washer
4 Flat Washer
8 #14 Sheet Metal Screw
UNIVERSAL FAN BRACKET INSTALLATION
1. Place the electric fan on a table or flat surface. (Motor facing up)
2. Place the two Large Mounting Brackets up against the two mounting surfaces of the fan shroud. (As shown in diagram below)
Make sure the brackets are flush with the bottom of the shroud.
3. Assemble the four , four Star Washers, and four M6 Lock Nuts onto the large brackets, leaving them
loose in order to slide the lock nuts down into the slots on the flat area of the fan shroud. Tighten the bolts making sure to
keep the shroud and brackets flush. (See Diagram below for proper configuration)
4. Take the four Small Mounting Brackets and install the pressed in studs into the slot on the large brackets. Use the
four M6 Lock Nuts and Flat Washers to secure.
Small Mounting Brackets are universal and can be mounted in any direction.
5. Take the fan and bracket assembly and determine the best location for mounting. Once you have location set, be sure to
tighten the Lock Nuts that hold the Small Mounting Brackets.
6. Take the eight #14 Sheet Metal Screws, and mount all brackets in desired locations by pre drilling with a 3/16” drill bit.
Other hardware can be used in place of screws if desired!
7. Finally, assure that all hardware is tightened properly and that fan is completely secure.
Note:
Note:
M6 x 12MM Hex Bolts
Please read these instructions completely before starting the installation.
Standard Screw Driver
Open End Wrenches
Drill 3/16” Drill Bit
Marker
TOOLS NEEDED
16700-InstructionSheet Rev-051211
Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on
vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the
parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting
the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.
Failure to follow instructions can lead to severe damage and personal injury.
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Large Mounting
Bracket
Small Mounting Bracket
Flat Washer
M6 Lock Nut
M6 Lock Nut
Star Washer
M6 x 12mm
Hex Bolts
The Universal Fan Mounting Bracket Kit is designed for 10”,
12”, 14” & 16" Derale Tornado Electric Fans. Brackets are
constructed of .090 aluminum with a clear anodized finish.
M6 Lock Nut
Flat Washer
M6 Stud Flat Washer
M6 Stud