Derale Performance High Output Dual Rad Fan Assembly - Manual

16028-16034-InstructionSheet
INSTALLATION INSTRUCTIONS
HIGH OUTPUT DUAL RAD FAN ASSEMBLY
PART # 16028 & 16034
KIT CONTENTS
QTY. DESCRIPTION
1 Left Shroud Assembly
1 Right Shroud Assembly
4 Shroud Assembly Screws
1 180° Thermostat Switch
1 3/8” Radiator Probe
1 Push-in Radiator Probe
1 1 x 1 Foam Pad
1 Retaining Clip
1 190° Thermostat Switch
1 3/8” x 1/8” Adapter Bushing
8 Mounting Rods
8 Mounting Clips
QTY. DESCRIPTION
8 1x1 Foam Pads
2 Relay Wire Harness
1 Red Butt Connector
2 Blue #10 Ring Terminals
2 Blue 5/16” Ring Terminals
3 Blue Butt Connectors
2 Blue Female Connectors
4 Blue Wire Tap connectors
7ft. 14 Gauge Wire
6 4” Wire Ties
4 #10 Sheet Metal Screws
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
Diagram #1
Engine
Puller Fan
Air Flow
Radiator
Please read these instructions completely before beginning installation
IMPORTANT
This fan assembly is designed for PULLER APPLICATIONS
Engine side of radiator. (See Diagram #1) ONLY
TOOLS NEEDED
5/8” Open End Wrench
11/16” Open End Wrench
3/4” Open End Wrench
Standard Screw Driver or
5/16” Nut Driver Drill
5/32” Drill Bit
12V Test Light
Wire Stripper
Crimping Tool
Teflon Tape
MOUNTING
1. Position the electric fan against the radiator in the desired
location.
2. Take the Plastic Rods provided and install through the eight
mounting holes on the shroud pushing them slowly into and
through the radiator core. (See Diagram #3)
Do not use excessive force when pushing Plastic
Rods through radiator core. Excessive force could cause
damage to the radiator fins and/or core. Plastic Rods should
not be inserted thru both the radiator and the condenser cores.
3. Take the 1 x 1 Foam pads provided and install them onto
the Plastic Rods now protruding through the radiator core.
(See Diagram #3)
4. Take the Plastic Clips provided, making sure they are in the
correct direction (Derale writing out) install onto the Plastic
Rods and cinch them until the 1 x 1 Foam Pads are
compressed. (See Diagram #3)
5. Cut off the excess Plastic Rod.
Caution:
Diagram #3
PRE-INSTALLATION
1. Identify the Right and Left Shroud Assembly
and Fan Shroud Mounting Screws
2. Using a table or flat surface, lay both the Right
& Left Shroud Assemblies on the flat surface
with the fan motors both facing up.
(See Diagram #2)
3. Slide both shrouds together lining up the
mounting holes. (See Diagram #2)
4. Carefully install the 4 Fan Shroud Assembly
Screws into each of the mounting holes and
tighten.
Do not over tighten! Note:
Mounting
Rods
Mounting
Clips
Foam
Pads
Electric Fan
Assembly
Diagram #2
Right Shroud Assembly
Left Shroud Assembly
(Page 1)