Derale Performance 13" High Output RAD Pusher Fan - Manual

16925-InstructionSheet
INSTALLATION INSTRUCTIONS
HIGH OUTPUT SINGLE RAD FAN
PART # 16925
Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com
WIRING
TIPS
Always disconnect vehicles battery before beginning installation involving your vehicles electrical system.
All 12 Volt Positive leads require the use of the appropriate fuse load rating to avoid damage to your vehicles electrical system.
Always insist on using only high quality components (wire, connectors, and switch) for use in installation of your new Derale
Electric Fan Assembly.
MOUNTING
1.
2.
Do not use excessive force when pushing Mounting Rods
through radiator core. Excessive force could cause damage to the
radiator fins and/or core. Plastic Rods should not be inserted thru both
the radiator and the condenser cores.
3. Take the 1 x 1 Foam Pads provided and install them onto the Plastic
Rods now protruding through the radiator core. (See Diagram #2)
4. Take the Mounting Clips provided, making sure they are in the correct
direction (Derale writing out) install onto the Plastic Rods and cinch
them until the 1 x 1 Foam Pads are compressed. (See Diagram #2)
5. Cut off the excess Mounting Rods.
Caution:
Position the Electric Fan in the desired location. Note the location and
remove fan.
Take the four Rubber Isolators and four Mounting Rods supplied. Using
one Mounting Rod at a time, install the Mounting Rod through the
Electric Fan, then through the Rubber Isolator and finally through the
Radiator Core. (See Diagram #2)
Please read these instructions completely before beginning installation
Engine
TOOLS NEEDED
Dyke Pliers
5/16” Open End Wrench
Standard Screw Driver or
5/16” Nut Driver
Drill
5/32” Drill Bit
12V Test Light
Wire Stripper
Crimping Tool
This fan assembly is designed for PUSHER APPLICATIONS.
Note: Replacement fan for M13 & A13 Derale shrouded fans.
KIT CONTENTS
QTY. DESCRIPTION
1 Fan Shroud Assembly
1 Relay Wire Harness
4 Mounting Rods
4 Rubber Isolators
QTY. DESCRIPTION
4 Mounting Clips
4 1x1 Foam Pads
1 #10 Sheet Metal Screws
Diagram #2
RELAY WIRE HARNESS MOUNTING
1. Taking into consideration fan placement & wire routing requirements, choose
a convenient location. Avoid mounting near HOT engine components.
2. Using the relay bracket as a template,
mark and drill a 5/32” hole in the proper
location.
3. Using the #10 Sheet Metal Screw
provided, install the relay/wire harness.
(See Diagram #3)
(Continues on reverse side)
RELAY
Diagram #3
Mounting
Surface
Mounting
Rods
Mounting
Clips
Foam
Pads
Electric Fan
Assembly
Air Flow
Pusher Fan
Diagram #1
Radiator
Rubber
Isolators
IMPORTANT