R&M Materials Handling VARIABLE SPEED CONTROLS ControlMaster Elite Manual - Manual (Page 16)

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
!
: (937) 328-5100
FAX: (937) 325-5319
16/31
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
3 PARAMETER ADJUSTMENTS
3.1 Control keypad operation
Drive status indications :
RUN
Motor is running
Motor rotation direction
STOP
Inverter is not running
READY AC power is on
ALARM Warning is on
FAULT
Fault is on
Control place indications :
I/O term
Terminals are the selected control place
Keypad
Control keypad is the selected control place
Bus/Comm
Control through Profibus is selected
Text lines :
Line 1 Location indication (parameter number)
Line 2 Description line (parameter name)
Line 3 Value line (parameter value)
Status LEDs :
ready
green Illuminates the AC-supply is on
run green Illuminates during run
Keypad I/O term
READY FAULT STOP RUN ALARM
Bus/Comm
P3.4.1.1.
Motor Nom Volt
400 V
START
STOP
enter select
reset
ready run fault
fault red Illuminates due to fault trip
Button descriptions :
reset Reset active faults START
Starts the motor if the keypad is the active
control location
select
Switch between two latest
displays
STOP
Stops the motor if the keypad is the active
control location
enter
Confirmation of selections
Fault history reset
Browse up the menus
Increase values
Move to previous menu level
Move cursor left
Exit edit mode
Browse down the menus
Decrease values
Move to next menu level
Move cursor right
Enter edit mode
Warning! Driving via keypad can cause a hazardous situation. Keypad control must not be
used.