Peerless-AV WL-ESA763PU-200 - Installation - Manual (Page 20)

20 of 25 ISSUED: 08-24-12 SHEET #: 180-9034-2 10-30-12
Plug the wireless receiver power cord back into the
wireless receiver. Position the wireless receiver
into the enclosure as shown, then close the elosure
door. Door may be locked with key provided if
desired. 15
Place the IR receiver and component cords inside
the cable management sheath (O) by pushing the
cables through the slit in the sheath. NOTE: The
sheath may need to be trimmed to length before
installing cords. 16
WIRELESS
RECEIVER POWER
CORD
O
Insert your component cable(s) (HDMI shown)
from your display through the cord access hole in
the bottom of the enclosure as shown and plug into
the wireless receiver. Coil up the excess cord and
secure with a cable tie (G). Store excess cord inside
enclosure. 10
COMPONENT
CABLE
14