Peerless-AV WL-ESA763PU-200 - Installation - Manual (Page 19)

19 of 25 ISSUED: 08-24-12 SHEET #: 180-9034-2 10-30-12
Insert the power cord from your display through the cord access hole in the bottom of the enclosure as shown. Plug
the power cord into the triple tap grounded outlet. Coil up the excess cord and secure with a cable tie (G). Store
excess cord inside enclosure.
Remove the tie from the IR receiver and insert the
end through the cord access hole in the bottom of the
enclosure as shown.
11
12
CORD ACCESS
HOLE
DISPLAY POWER
CORD
IR RECEIVER
Position the IR receiver on the front of the display
within line of sight of your remote as shown. Remove
the adhesive backing from the IR receiver eye and
attach to the display. Coil up the excess cord near
the wireless receiver enclosure and secure with a
cable tie (P). Store excess cord inside enclosure. 13
IR RECIEVER