Peerless-AV LCC-36-CS - Installation - Manual (Page 7)

7 of 14 ISSUED: 09-27-04 SHEET #: 100-9005-8 12-13-12
Flush Mount Installation
B
D
Screw reducer (D) into ceiling plate (B) until notch
in reducer is aligned with one of the four holes in
ceiling plate and set screw (I) is at least partially
covered by ceiling plate as shown in fi gure 3-1.
Secure reducer with one M5 x 10 mm F-type
socket pin screw (P) using security allen wrench
(G) as shown in fi gure 3-2. Note: Slotted set
screw (N) is used to jam against the threads of
the reducer to prevent any excess movement of
the tube assembly (A). Do not overtighten screw;
overtightening screw will damage threads making it
diffi cult to separate the products.
Skip to step 4.
I
fi gure 3-1
P
fi gure 3-2
SLOT
SLOT
D
ACC 810 (SOLD
SEPARATELY)
1/2 -13 THREADED
ROD
Screw threaded rod adapter (ACC 810) into
extension column connector (ACC 109). Align slot
in threaded rod adapter with one of the top holes
in extension column connector. Insert and tighten
one #10-32 x 3/8" socket pin screw provided with
extension column connector through extension
column connector into slot on threaded rod adapter
using 4 mm security allen wrench (G). See fi gure 3-3.
Align slot in reducer (D) to one of the bottom holes
in extension column connector. Insert and tighten
one #10-32 x 3/8" socket pin screw provided with
extension column connector through extension
column connector into slot in reducer. See fi gure 3-4.
Note: Slotted set screws provided with extension
column connector are used to jam against the
threads of each connecting joint to prevent any
excess movement. Do not overtighten screws;
overtightening screws will damage threads making it
diffi cult to separate the products.
Skip to step 4.
SLOT
ACC 810
THREAD-
ED ROD
ACC 810
THREAD-
ED ROD
SLOT
D
Installation to
Threaded Rod
Accessory ACC 810 (not evaluated by UL),
threaded rod adapter, is required.
SOCKET
PIN
SCREW
ACC 109
SOCKET
PIN
SCREW
ACC 109
(SOLD SEPA-
RATELY)
fi gure 3-3
fi gure 3-4
A
N
SET
SCREW
SET
SCREW
ACC 109