Peerless-AV LCC-36-CS - Installation - Manual (Page 14)

14 of 14 ISSUED: 09-27-04 SHEET #: 100-9005-8 12-13-12
Using a carpenter's knife, cut out any sections of tilt covers (S) necessary to allow them to snap together over verti-
cal covers (Q) as shown in fi gure 9-1. Note: Cut out sections of one tilt cover should mirror cut out sections of the
other. Use glue (V) on the inside edge of one of the two tilting covers (S) so that the two sides will stick together
when they are connected. Insert tabs of tilt covers into slots of tilt bracket (C) and snap tilt covers together.
Note: Alcohol pad (W) may be used for clean up of glue.
© 2012 Peerless Industries, Inc. All rights reserved.
Peerless is a registered trademark of Peerless Industries, Inc.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Installation of Tilt Covers in the Vertical Position
Installation of Tilt Covers in the Horizontal Position
Using a carpenter's knife, cut out any sections of tilt covers (S) necessary to allow them to snap together over verti-
cal covers (Q) as shown in fi gure 9-1. Note: Cut out sections of one tilt cover should mirror cut out sections of the
other. Use glue (V) on the inside edge of one of the two tilting covers (S) so that the two sides will stick together
when they are connected. Insert tabs of tilt covers into slots of tilt bracket (C) and snap tilt covers together.
Note: Alcohol pad (W) may be used for clean up of glue.
fi g. 9-1
S
C
Q
S
Q
fi g. 9-1 C