PowerWalker AS_400 Card 3 - Manual (Page 8)

8
3. Installing
3.1. Installing the Card
The Dry contact Management Card can be installed in UPS equipped with a communication bay
without turning off the UPS or disconnecting the load.
To install the Dry contact Management Card:
1. Remove the communication bay cover from the UPS. Retain the screws.
2. To prevent electrostatic discharge (ESD), place one hand on a metal surface.
3. Slide the card into the open slot and secure with the screws removed in Step 1
Figure4. Installing the Card
3.2. Connecting the Card
To connect the card to the computer and start the configuration:
1. Plug the RJ-45 end of the supplied serial cable into the Settings port on the card
2. Plug the other end of the serial cable into the serial COM port on the computer.
Figure5. Connecting the Card