PowerWalker AS_400 Card 3 - Manual (Page 18)

18
Enter Y or y. below menu will display as below, if enter any other character, the only main menu
displays (see Figure 12) and not show “Default All Configuration Parameter” string and do not
change to default value
Default All Configuration Parameter
-----------------------------------------------------------------------------
Dry contact Management Card
-----------------------------------------------------------------------------
1. Function Segment Logic
2. Output Segment Function Configure
3. Input Segment Function Configure
4. Function Segment Active Delay Time
5. Return to Default Configuration
6. Firmware Version
0. Exit
-----------------------------------------------------------------------------
Please Enter Number:
Figure24. Default all configuration parameter success menu
4.8. Firmware Version menu
When main menu Type 6 and press Enter. The menu displays the Firmware Version and
development data as below, in this menu type 0, the menu will return to Figure12. Main menu
-----------------------------------------------------------------------------
Firmware Version
-----------------------------------------------------------------------------
Firmware Version:00.05 2010/06/01
0. Exit
-----------------------------------------------------------------------------
Please Enter Number:
Figure25. Firmware version menu
4.9. Exit menu
When main menu Type 0 and press Enter. The menu displays the Exit setting mode information
as below