Peterson Strobe Center 5000-II - Manual (Page 37)

Page 35
Key #1 returns to the PICK NAME sequence.
Key #2 permits DELetion of old STRCH file.
Key #3 returns the tuner to the Run Mode, using standard
unstretched tuning values.
Key #1 deletes file and returns to STRCH Menu.
Key #2 returns to the Stretch Menu.
Key #3 returns to the Stretch Menu with no changes.
Key #4 selects STRCH file in memory to copy from.
STRCH = XXXX
ALREADY EXISTS
RE-
NAME DEL RUN
1 2 3 4
Use the #3 function key to return the tuner to the Run Mode using standard unstretched tuning. The #1 function button returns
you to the Name Selection screen, permitting you to make a different choice. Use the #2 function key when you want to
DELete the previously used STRCH file name from your custom stretch memory locations. Whenever you choose to Delete
a custom STRCH file, the tuner will request confirmation of the file deletion before performing the erasure:
DELETE STRCH = XXXX
ARE YOU SURE?
YES NO
1 2 3 4
Choose the #2 function key to return directly to the Stretch Menu without deleting the selected STRCH file or copying a file.
Use the #1 function key to Delete the selected custom STRCH file. After deleting the file, the tuner returns to the Stretch
Menu.
If, instead, a valid name for the new stretch file had been created, the display screen will change to:
COPY THIS STRCH =
XXXX XXXX XXXX XXXX
XXXX XXXX XXXX XXXX
CNCL SLCT
1 2 3 4
Use the #3 function key to return the tuner to the Stretch Menu screen with no copy file created.
Use the Pitch Down and Pitch Up Keys (Down Arrow - cursor forward and down; and Up Arrow - cursor up and back) to
scroll the cursor through the programmed stretches. When the cursor is on the eighth Name on any page of stored stretches,
press the Down Arrow key again and the tuner will display the next memory page of your custom stretches. Similarly, when
the cursor is on the first Name of any custom stretch screen, pressing the Up Arrow key will show the previous page of
custom or preprogrammed stretches.
When the cursor is on the stretch memory file you desire, press the #4 function key to select that stretch into the operation
buffer of the tuner. The display will then proceed to a confirmation screen: