Configuring the dualcon – B&B Electronics DUALCON-3 - Datasheet User Manual
Page 5

DUALCON-3 USERS GUIDE
4. CONFIGURING THE DUALCON
!
! WARNING !
DO NOT OPEN UNIT OR ADJUST SWITCHES WITH
POWER SUPPLY, INPUT OR OUTPUT CONNECTED
The DUALCON is an extremely versatile device which can support many different
types of input. The unit is configured by turning the power off, selecting the
internal switch settings required and turning the power back on.
To open the DUALCON, 2 catches just below the outer terminal blocks must be
pushed in gently, one at a time. The front of the case can then be pulled and the
unit will come out of the box.
Press here gently
There are 4 switch banks, S1, S2, S3 and S4, located inside the DUALCON as
shown below:
Switch 10 is OFF
Switch 11 is ON
Switch 12 is OFF
OFF = 0
ON = 1
12
11
10
Switch S3
12
1
12
1
1 12
Switch S2
Switch S4
1 12
Switch S1
Switch S1 and S2 configure the input type and range, and switch S3 and S4
configure the output types, ranges and a few additional functions. The switch
settings are explained in the next few pages. The diagrams refer to switch
positions 0 and 1, with 0 being OFF and 1 being ON. This is illustrated in the
picture above.
IIG-020901 Page
5