B&B Electronics 850-14200--95 - Manual User Manual
Page 6
3
Make sure to deploy the iMcV-T1/E1/J1 Repeater modules in pairs, as
Host/Remote.
Make sure the Remote Chassis is not managed.
Managed Modules
To manage iMcV-T1/E1/J1 Repeater modules, an SNMP agent must be present;
the iMediaChassis requires an SNMP management module. For a managed
environment, first manually configure all of the desired DIP Switch selectable
features to match what will be configured through the SNMP Management
Module.
NOTE
Before installing the modules, they must be configured for Host/Remote via the DIP
Switches. The Master/Slave condition requires this configuration:
S1-10: ON Remote Unit Enabled (only at the REMOTE end) (Remote)
S1-10: OFF Remote Unit Disabled (only at the LOCAL end) (Host)
Use the Graphical User Interface (GUI) to enable features by using the iView
2
SNMP management software. In a managed chassis, the software settings take
priority over the SNMP enabled feature DIP Switch settings. Make sure that the
software settings match the desired configuration requirements for the
installation.
iView² Management Software
iView² is the B&B Electronics management software designed specifically for the
B&B Electronics “iMcV” family of modules. It features a GUI and gives network
managers the ability to monitor and control the manageable B&B Electronics
products.
iView² is available in several versions, including WebServer version 3.0, and can
also function as a snap-in module for HP OpenView Network Node Manager and
other third party SNMP Management software.
iView
2
supports the following platforms:
Windows 2000
Windows XP
Windows Vista
Windows 7