beautypg.com

Administration – snmp – B&B Electronics 708M12-HV - Manual User Manual

Page 25

background image

(Revised 8/5/2009)

Page 25 of 136

Administration – SNMP

The SNMP tab under the Administration category shows a list of IP Addresses that act as SNMP Traps.
The Read-Only, Read-Write, and Trap Community Names are also shown here.

By selecting the Modify button, you will be able to change any of the fields listed. This allows the user to
set an IP address for a Trap station or change the Community Names. If the SNMP Notification Trap is
enabled, systems that are listed as a Trap station will be sent the corresponding notification trap. To restore
a Trap to “Value Not Configured”, enter ‘0.0.0.0’.

See also other documents in the category B&B Electronics Accessories communication: