B&B Electronics 708M12-HV - Manual - Manual (Page 112)

(Revised 8/5/2009) Page 112 of 136
CLI Commands, Continued…
Save or Reset the Configuration Settings
Command Name config
Description Save or reset configuration settings
Syntax config s[ave] | r[eset]
Parameters save
save current running configuration settings.
reset
reset configuration settings to factory defaults.
Examples N-TRON/Admin> config save
Save Settings...
Settings have been saved.
N-TRON/Admin> config reset
Resetting to factory defaults...
Load factory default settings [y/n]?y
Keep IP, subnet mask, and gateway addresses [y/n]?y
Keep current user names and passwords [y/n]?y
…
NOTES
Dongle Operations
Command Name dongle
Description Perform dongle operations
Syntax dongle info | format [-m model] | compare | erase
Parameters info
Show information about the dongle (factory access only).
format
Format the dongle to factory default (factory access only).
-m model
Dongle model number: 1=At32K or 2=At64K (default)
compare
Compare the configuration on the dongle to the switch.
erase
Erase the switch configuration on the dongle.
Examples N-TRON/Admin> dongle compare
Comparing dongle configuration...
The configurations are identical.
N-TRON/Admin> dongle erase
Erasing dongle...
Dongle erase completed.
NOTES
Show or Set IGMP Configuration
Command Name igmp
Description Show or set IGMP configuration. If no parameters are specified, this command will show
the IGMP configuration (same as -show parameter).
Syntax igmp [-show] [-status state]
Parameters -show
Show configuration.
-status state
Set the IGMP status to e(nabled) or d(isabled).