B&B Electronics 850-18100--27 - Manual User Manual
Page 8
5
If the command cleandb is applied to an SNMP Management Module, all the
settings for the modules will be removed, but the Configuration Control modules
will still be based on the last change made, while those without Configuration
Control will be set to their default settings.
NOTE
If the end user has a mixture of standard iMcV-Modules as well as Configuration Control
iMcV-Modules, it is important to understand how SNMP and DIP Switches will impact the
cards depending on their capability. Standard iMcV-Modules cannot be upgraded to
Configuration Control capability, so it is strongly recommended to set the DIP Switches on
the modules and then configure them via software to match the same settings.
iView² Management Software
iView² is the B&B Electronics management software designed specifically for the
B&B Electronics “iMcV” family of modules. It features a GUI and gives network
managers the ability to monitor and control the manageable B&B Electronics
products.
iView² is available in several versions, including WebServer version 3.0, and can
also function as a snap-in module for HP OpenView Network Node Manager and
other third party SNMP Management software.
iView
2
supports the following platforms:
Windows 2000
Windows XP
Windows Vista
Windows 7
Please see the SNMP Management Module installation guide for software
configuration options.
Unmanaged Modules
Before installing the module in an unmanaged chassis, manually configure all of
the desired DIP Switch selectable features. Refer to Tables on page 7 and 8.
Modules must be configured as a HOST-REMOTE pair via DIP Switches. Modules
are shipped in the default setting as a HOST.
HOST: S3-2
OFF