B&B Electronics 850-18100--27 - Manual - Manual (Page 11)

8
Switch Settings for Switch S3
S W
I
T C H
S
3
Reserved
S3-1: ON Reserved
S3-1: OFF Reserved default
Remote Management
S3-2: ON Remote Management Enabled (only at the REMOTE end)
S3-2: OFF Remote Management Disabled (only at the LOCAL end) default
Loopback Selection iVIEW 2
S3-3: ON S3-4: ON None iVIEW 2 default
S3-3: OFF S3-4: ON Fiber Analog Loopback iVIEW 2
S3-3: ON S3-4: OFF Internal Fiber Loopback iVIEW 2
S3-3: OFF S3-4: OFF Copper Remote Loopback iVIEW 2
Monitor/Boost Mode
S3-5: ON S3-6: ON Normal Operation (No Boost) default
S3-5: OFF S3-6 ON 20 dB
S3-5: ON S3-6 OFF 26 dB
S3-5: OFF S3-6 OFF 32 dB
Fault Loopback
S3-7: ON Send AIS is sent back toward the fault on the RJ-45 port iVIEW 2
S3-7: OFF AIS is only sent toward the fiber on detecting a fault on the
RJ-45 port iVIEW 2 default
Fiber Type
S3-8: Factory Configured DO NOT CHANGE
S3-9: Factory Configured DO NOT CHANGE
S3-10: Factory Configured DO NOT CHANGE