B&B Electronics 714FX6-SC_ST - Manual - Manual (Page 29)

(Revised 2010-2-24) Page 29 of 154
Administration – SNMP
The SNMP tab under the Administration category allows SNMP to be disabled or enabled, and shows a list
of IP Addresses that act as SNMP Traps. The Read-Only, Read-Write, and Trap Community Names are
also shown here.
By selecting the Modify button, you will be able to change any of the fields listed. This allows the user to
set an IP address for a Trap station or change the Community Names. If the SNMP Notification Trap is
enabled, systems that are listed as a Trap station will be sent the corresponding notification trap. To restore
a Trap to “Value Not Configured”, enter ‘0.0.0.0’.